NNNnnoooooooooo!
How do you fit a square peg into a round hole?
The set of holes on the right has been drilled out to accommodate the square leads of the LED. Compare those to the set of holes on the left which are the original size.
Anool is drilling out one board (over 700 holes) and we are getting the rest drilled at the factory (thousands of holes). The only problem is that we loose the connect through the board and will need to solder on both sides. Hope Anool can get a board built up this week and test the rest of the circuitry!
Rev two anyone?
No comments:
Post a Comment